FAQ

  • Panels are manufactured to original imperial measurements, feet and inches, (2’ x 6’) or approx. 600mm x 1800mm (60cm x 1.8m).
  • Selected designs are available in 900mm x 1800mm (Fleur, Maze, Snowflake, Acorns NSW, Geometric and Fishscale).
  • Fishscale is available in aluminium 600mm x 1800mm and 900mm x 1800mm and zincalume 1200mm x 1800mm and 1200mm x 2400mm.
  • St Catherine, St Patrick and St Dennis are only available 600mm x 600mm in aluminium or zincalume, POA.
  • Our pressed metal is manufactured from quality aluminium
  • Panels are heat and rust resistant.
  • We do not recommend powder coating as coating can chip and crack when panels and penetrations are cut, overlaps cannot be gapped, and panels cannot be easily touched up or changed to a different colour. A seamless result can be achieved by ‘no more gapping’ any overlaps and painting in any colour and finish with a water based enamel paint using a foam roller, brush or spray gun.
  • Pressed metal panels are pressed in quality grade aluminium which can be easily painted any colour or finish when primed.
  • Pressed metal is easily cleaned. When installed raw, wipe over with Mr Sheen or similar SILICON FREE polish with a soft cloth or Enjo style cloth. After cooking wipe clean with a damp cloth or warm soapy water. For a  painted finish wipe over with a soft damp cloth or warm soapy water, do not use scourers.
  • Pressed metal is suitable for internal and external use.
  • Pressed metal is heat resistant and therefore suitable for use behind stove tops and combustion heaters and BBQ’s.
  • We offer a full installation service for a professional finish and are happy to provide a free measure and quote.
  • It is easy to install for a confident DIY. We recommend using stud adhesive or liquid nails when applying direct to existing plasterboard walls and ceilings. Soft sheet nails or pop rivets can also be used when fixing to timber or steel batons. Waterproof silicone is used to seal the edges for splashbacks and the pressed metal can be installed over existing tiles as long as the surface is even and in good repair and free of grease and oils. The metal can be cut using a heavy duty Stanley knife with a sharp blade and a straight edge or aviation snips can be used for trimming. When cutting penetrations (eg. Downlights, air conditioning vents) hole saws and grinders with a 1mm blade may be used. We do not recommended using in shower alcoves but it is suitable for bathroom and toilet walls as long as the correct systems are followed.
  • We have over 100 different designs on offer, to suit traditional through to contemporary  buildings.
  • Pressed metal is extremely versatile. It has great durability and if cared for properly will last for many years, ceilings in particular will last over 100 years. It can be used for a variety of features eg. Kitchen and bathroom splashbacks, ceilings, feature walls, door inserts, bathroom wall paneling, bed heads, paneling rooms and hallway wall paneling, gables, out door BBQ areas and features or just about anything you can think of, inside or outside.
  • We can organise delivery Australia wide.